v e r . 2 0 1 8 - 0 7 - 0 2
G r i z z l y
49
20.3.4. Position seat at an angle of 9.9 degrees with respect to the ground. See Figure 20.3.4. This angle will be
obtained by dividing the seat with the backrest (cradle) by one opening. Bolts locking the seat position should be
located in the third hole of the comb adjusting the angle of the seat viewed from buggy front. Perform the operation
in accordance with point 8.31 and 8.32 of this instruction.
Fig. 20.3.4.
20.3.5. Adjust height of backrest and depth of seat according to indications from this instruction manual as per child's
height. It should be borne in mind that the child's head must be supported to its very top and thighs should rest on the
seat across the entire length.
20.3.6. Place footrest in such a position that the angles between the feet and shanks and shanks and thighs are 90
degrees. During adjustment, follow the instructions contained in this manual.
20.3.7. Adjust five-point straps of buggy according to child's height in accordance with 8.37 and 8.38 on pages 29
and 30 of this manual.
20.3.8. CAUTION!!! Five-point harness which the Grizzly is equipped with does not constitute a safety device when
transporting a child in buggy with a motor vehicle. To protect the child, use the ilial-thoracic belts specially designed
for this purpose and mounted in the motor vehicle. These belts must comply with PN ISO 7176-19: 2007 standard.
20.4. Mounting Grizzly buggy in a motor vehicle for use as a seat.
20.4.1. First, prepare and set up Grizzly buggy according to the strictly specified settings given in point:
20.3.
Preparation of Grizzly buggy for assembly in a motor vehicle for use as a seat.
20.4.2. Next, make sure that the vehicle in which you want to transport the buggy and use it as a seat is adapted to it.
20.4.3. CAUTION – THE CHILD MAY NOT BE TRANSPORTED IN UNFIT VEHICLES!!!
20.4.4. Place buggy facing forward in a specially designed place in the motor vehicle
20.4.5. Secure truck's central parking brake.
20.4.6. Anchor buggy to motor vehicle using the four-point harness attachment system. Straps and attachment points
of the buggy in the vehicle must comply with guidelines of ISO 10542. The belts should be fastened to each of 4
securing points (
Fig. 20.2.1. Hook
) of buggy separately, from the front to the rear.
CAUTION! Each harness should be
as tight as possible to prevent the buggy from moving in the vehicle!
20.4.7. CAUTION – STRAPS FOR ASSEMLBY OF BUGGY ARE NOT SUPPLIED BY THE MANUFACTURER OF THE GRIZZLY
BUGGY!!!
20.4.8. Place child in buggy and fasten it with the five-point harness, which the Grizzly is equipped with.
20.4.9. In order to protect the child in the event of an incident, fasten it with the ilial-thoracic belt, which comprises
the equipment of the motor vehicle. This belt must comply with the PN ISO 7176-19: 2007 standard.
