24
STEP 3: Test the System
START
START UP AND
TESTING FINISHED
TIP: To test the BBS, perform the self-test feature via control submenu (see manual,
section 2.2.3, "Self Test")
Turn OFF the upstr
eam circuit breaker
en LED will flash and
The OUTPUT Gre
ON BATT, indicating
the LCD displays
er is supplied from
that output AC pow
battery power.
Observe the Red A
larm LED. If it is on
or flashes, follow t
he troubleshooting
sequence as belo
w:
1.
Investigate the
alarm
2.
est with the
Perform a self-t
d
load(s) connecte
3.
self-test, verify
If it passes the
that the loads ar
e operating
normally
4.
See the trouble
shooting chart
manual,
in the MP2000E
Section 2.4.3
5.
Contact
Myers
Emergency Power
Systems
.
techni
cal support
y shows Standby
The LCD displa
LCD display
In 30 seconds, The
changes to " ON LI
NE", the Green
Output LED is lit in
dicating Input power
to be within accept
able frequency and
voltage ranges and
the output is
powered from utilit
y.
LCD display
In 30 seconds, The
NE", the Green
changes to " ON LI
dicating Input power
Output LED is lit in
able frequency and
to be within accept
the output is
voltage ranges and
powered from utilit
y.
Summary of Contents for MP Series
