3G-SDI ST2110 Over IP Gateway Converter
Operation Manual
© MuxLab Inc. 2022
26
Firmware Upgrade
The 500767-2110-RX comes with the firmware pre-installed, please check the
MuxLab Web site to verify if a newer version is available. You may go to our
support software/firmware page of our Web site to download the required files:
https://muxlab.com/support?section=software-and-firmware
The 500767-2110 RX has both an FPGA and MCO (Micro-Controller Unit), and
each has its own firmware. The user may upgrade the FPGA and MCU firmware
from this page as follows:
1. Download the upgrade 500767-2110 firmware file (which includes the
FPGA and MCU code) from the MuxLab website (found under the
Support Software/Firmware page).
2. Go to the setting page on the unit Web interface.
3. In the
Upgrade Firmware section press on the “Chose File” button and
locate and select the file you downloaded and click on the “Upload”
button. It may take 30 seconds or more to install the new version. Allow
the process to complete without interruption.
Network Settings (RX)
The user may set the network parameters of the 500767-2110 RX, including
enabling or disabling DHCP, setting a static IP Address, Netmask Address, and
Gateway Address, and then pressing on “Apply”.
The 500767-2110 RX default IP addresses are set to DHCP. If no DHCP is
available on your network the RX will default to the following static IP Addresses:
•
1G Management/Control port (Console LAN): 192.168.168.67
•
Media/Data 1 port (Media 1): 192.168.168.68
•
Media/Data 2 port (Media 2): 192.168.168.69
Note: If the user changes the static IP addresses from their default values, then
the user defined static IP Addresses will be used when do DHCP server is
Figure 10: 500767-2110 RX Settings page
