3G-SDI ST2110 Over IP Gateway Converter
Operation Manual
© MuxLab Inc. 2022
17
Firmware Upgrade
The 500767-2110 comes with the firmware pre-installed, please check the
MuxLab Web site to verify if a newer version is available. You may go to our
support software/firmware page of our Web site to download the required files:
https://muxlab.com/support?section=software-and-firmware
Important Note:
Use the 1G Port (port: Console LAN) to upgrade the unit
Firmware.
The 500767-2110 TX has both an FPGA and MCO (Micro-Controller Unit), and
each has its own firmware. The user may upgrade the FPGA and MCU firmware
from this page as follows:
1. Download the upgrade 500767-2110 firmware file (which includes the
FPGA and MCU code) from the MuxLab website (found under the
Support Software/Firmware page).
2. Go to the Setting page on the unit Web interface.
3.
In the Upgrade Firmware section press on the “Browse” button and
locate and select the file you downloaded, and click on the “Chose File”
button. It may take 30 seconds or more to install the new version. Allow
the process to complete without interruption.
Network Settings (TX)
The user may set the network parameters of the 500767-2110 TX for the two (2)
10G Media/Data ports (ports: Media 1 & Media 2 is installed) and the one (1) 1G
Management/Control port (port: Console LAN), including enabling or disabling
DHCP, setting a static IP Address, Netmask Address, and Gateway Address,
and the
n pressing on “Apply”.
The 500767-2110 TX default IP addresses are set to DHCP. If no DHCP server
is available on your network the TX will default to the following static IP
Addresses:
•
1G Management/Control port (Console LAN): 192.168.168.64
•
Media/Data 1 port (Media 1): 192.168.168.65
•
Media/Data 2 port (Media 2): 192.168.168.66
