3G-SDI ST2110 Over IP Gateway Converter
Operation Manual
© MuxLab Inc. 2022
19
2.1.6 Configuring the 500767-2110 as a RX
The following will explain how to configure the 500767-2110 as a RX from the Web
interface.
Since the 500767-2110 is a Transceiver, it may be set as a Transmitter (TX) or
Receiver (RX). To set the unit as a RX, set Dip Switch Pin #1 to the UP position.
The 4-Pin Dip Switch is located on the front panel as shown below.
2.1.7 RX Media Page
To connect into the RX, you may open a Web browser and type its IP address.
Once connected, the Media page appears. This page contains the main settings
to properly receive audio, video and ANC data signals from the 500767-2110 TX.
There are different ways of configuring the unit: Manual SDP and NMOS.
Additionally, when using Manual configuration, the Media settings can be
either ANC Data or Manual.
The following example shows settings for Manual input type and ANC Data Media
Settings.
