Muton XPJ-1682WR, Operation Manual

Page: 65 / 158

Setup 1: User Type 65
PF Adjust 1: Initial Print
• After the initial adjustment printing, cut the media.
• With a ruler, measure the length between “ ” in the pattern.
In the example below, the measured place is shown in orange dotted lines and arrows.
PF Adjust 2: Initial Change
Performs Initial Print. Enter the “Feed Length” and tap [Enter].
Setting values
100 mm to <250 mm> to 500 mm
<> indicates the initial value.
Note
The length of media that is fed (feeding length) for initial adjustment printing is normally set at 250 mm. If you increase the feeding length,
the accuracy of the Media feed adjustment improves.
To change the feeding length, tap or on the front panel and change the set value.
Use or to enter the adjustment value, and tap [Enter].
Setting values
You can set a value that is b50
mm and -50 mm of the feed length
configured in “Initial Print”.
** : PF Adjust 1
Initial Print
** : Initial Print :
Feed Length: 250 mm
** : PF Adjust 2
Initial Change
** : Initial Change :
Init. : 250.0 mm / 250 mm