MUTOH XPJ-461UF, Operation Manual, Page: 71 / 162

Set1: User Type 71
**>5: MediaSetting
This is for setting the conditions for placing the media on the table.
Submenus
For entering the media width and length,
and setting the origin position.
• Carry these out with the media set in
place on the table.
"Specify the print start position" P. 36
,
Step 4 and Step 7.
For entering the media width and length
only.
"Specify the print start position" P. 36
,
Step 4 and Step 5.
Enter the origin of the job.
"Specify the print start position" P. 36
,
Step 6 and Step 7.
Off / <On>
<> indicates the default setting.
• If you select “Detailed-Set: On”, you will
have to input the media size and origin
position after tapping
each time
you set a media on the table. However,
you can eliminate the need for such
input by tapping the [Cancel]. If you do
so, the values set in the User Type will be
used.
• If you select “Detailed-Set: Off”, “Ready
to Print” will be displayed after tapping
each time you set a media on the
table.
The currently selected User Type values
will be used for the media size and
origin position.
• Even when "Detailed-Set" is set to Off,
you can enter media height, obstacle
detect, media size and origin position
from the “**: Media Setting1 Set Media”
by tapping [Cancel] while the message
"Print Ready" or “Set media then tap [
∧
]
key.” appears on the panel.
Select the detection accuracy of the
obstacle sensor when loading media into
the printer.
If printing fails due to failure to detect
media warp with "Normal" mode, try
"High-Accuracy" mode.
Normal / <High-Accuracy>
<> indicates the default setting.
Type ** : 5
Media Setting
** : Media Setting1
Set Media
** : Media Setting2
Size
** : Media Setting3
Origin
** : Media Setting4
Detailed-Set
** : Media Setting5
Obst. Check Mode