Set1: User Type 69
PF3. Confirm Print
• With a ruler, measure the length between “+” in the pattern.
• If there is discrepancy between the value set for “FeedLength” and the value measured, carry the procedure out again from
1. “Initial Print”. If there is no discrepancy, go to 4. “PF4. Micro Print”.
•
In the example below, the measured place is shown in blue dotted lines and arrows (the blue parts are not actually printed).
PF4. Micro Print
• Observe the pattern and verify the micro adjustment value. In the pattern, look for a place that has least white lines or
overlapping in images. The number printed below the pattern is the micro adjustment value.
•
Enter the Micro adjustment value according to the test pattern print.
Performs Confirm Print. Enter the “FeedLength”, and tap [Enter].
Print a “+” mark at the beginning, feed the media according to the setting value,
and print another “+” mark.
Setting values
100 mm to <250 mm> to 300 mm
<> indicates the default setting.
Performs Micro adjustment print.
Enter the appropriate micro adjustment value according to the test pattern
print.
Note
The micro adjustment value saved becomes the pattern’s standard value.
For example, if “-0.20” is saved as the micro adjustment value and a pattern is printed again, the number below the center pattern changes
from “0.00” to “-0.20”, and the left edge to “+0.30” and right edge to “-0.70”.
** : PF Adjust3
Confirm Print
** : Confirm Print
FeedLength :
250 mm
** : PF Adjust4
Micro Print
-0.50
-0.20
-0.10
0.00
+0.10
+0.20
+0.50
-0.50
-0.10
-0.20
Micro adjustment value
Not adequate
Adequate
Not adequate
Summary of Contents for XPJ-461UF
Page 102: ...102 Menu during printing ...
Page 146: ...146 How to perform initial ink charging after ink discharge ...
Page 161: ...List of specifications 161 ...
Page 162: ...XPJ461UFE A 01 ...