MUTOH Falcon Outdoor Jr., Operation Instructions Manual, Page: 47 / 71

Falcon Outdoor Jr. – Operation Instructions
Page
47
PN: MAI-75039
Rev. 1.A – 07/26/05
1 = Fixed flange
2 = Media winding direction
Note :
Do not drop the media roll over the scroller as this might damage the scroller end caps.
Damaged end caps may cause media tracking problems.
All Mutoh recommended roll media are rolled up with the printable side facing the
outside, so that you can load the roll media easily.
Step 7 :
Installing the scroller slip ring
Install the scroller slip ring onto the scroller. Slide the scroller slip ring on the left side of the
scroller (side with fixed flange).
Step 8 :
Installation of the scroller.
Install the scroller as follows :
¾
Stand at the back side of the printer, holding the scroller with the fixed flange side in your left hand.
¾
Slide the scroller (left side) into the scroller receiver, as shown in the illustration.
¾
Push the scroller (Right side – movable flange side) down into the right scroller receiver. You will
notice it dropping nicely into place.
Step 9 :
Locking the scroller slip ring
Lock the scroller by sliding the scroller slip ring onto the scroller rollers. The scroller slip ring will prevent
unwinding of the roll media from the scroller when roll media is still not loaded in the machine.