MUTOH Falcon Outdoor Jr., Operation Instructions Manual, Page: 15 / 71

Falcon Outdoor Jr. – Operation Instructions
Page
15
PN: MAI-75039
Rev. 1.A – 07/26/05
¾
Only use Eco-Solvent Plus ink and appropriate Eco-Solvent Plus cleaning liquid. Using other ink (e.g.
dye or pigment) will cause permanent damage to the printer.
¾
Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunctioning in
the printer.
¾
Do not touch the cutter blade. Doing so may result in bodily injury.
¾
Do not cut hard objects or drop the cutter. Doing so may damage or chip the cutter blade.
¾
Do not bend or pull the waste fluid tube. Doing so may cause that the waste fluid will leak out and
malfunction in the product.
¾
Do not touch the cleaning wiper or the head cap unit while cleaning the cleaning wiper. Doing so may
result in poor head cleaning because of oil on your hands.
¾
Do not tilt the printer, stand it against a wall or turn it upside down. Doing so may cause ink to leak
inside the printer. Movement after transport is also not covered by the warranty.
¾
When installing options, do not touch the elements on the circuit board. The elements on the boards
can be very hot and can cause burns.
¾
Have two or more people unpack and assemble the printer.
¾
When lifting the printer out of the packing box, be sure to remove the vinyl cover first, then grab the
holding grips on the sides of the printer. Lifting the printer with the vinyl cover on may cause your
hands to slip and drop or damage the printer.
¾
Have two or more people transport the printer.
¾
Ensure that the plug has been disconnected from the power socket when it is not to be used for a long
time.
¾
Earth wires must be connected to wires or terminals that fulfil the conditions below.
o
Earth terminals of power sockets
o
Earth wires with copper morsel that is at least 650 mm under the ground
¾
Earth wires must be connected to wires or terminals that fulfil the conditions below.
¾
When setting roll media, place it on top of a desk or other flat surface. Setting roll media with the
scroller standing up may damage them.
¾
Keep the printer horizontal during transportation.
¾
Be sure to do the following before attaching options.
o
Turn the printer off.
o
Unplug the power cord from the socket.
o
Unplug cables connected to the printer. Otherwise, damage to the printer or your computer may
occur.
o
Remove electrostatic charge from your clothes and body by touching the metal parts of the printer.
o
Electronic components such as the memory may malfunction if exposed to an electrostatic charge.