MUTOH Falcon Outdoor Jr., Operation Instructions Manual, Page: 29 / 71

Falcon Outdoor Jr. – Operation Instructions
Page
29
PN: MAI-75039
Rev. 1.A – 07/26/05
3.6. INSTALLATION OF THE WASTE BOTTLE
In the accessories box, you will find the Waste Bottle Bracket together with the Waste Bottle.
After unpacking and assembling the Falcon Outdoor Jr. printer, you must install the Waste Bottle Bracket
with the Waste Bottle.
Important :
Do NOT power on the unit before installation of the Waste Bottle.
Please follow the instructions below to install the Waste Bottle.
Step 1 :
Screw the Waste Bottle Bracket onto the Scroller System on the left side standing at the rear of
the unit. (2 screws) (Please refer to picture A on the following page.)
Step 2 :
Remove the adhesive tape holding the Waste Tubes to the unit.
Step 3 :
Push the big Waste Tube in the hole in the middle of the top of the bracket. Check if the tube is
fixed securely. (Please refer to picture A on the following page.)
Step 4 :
For the 2 smaller tubes, do as follows :
¾
Slide the upper plastic ring upwards.
¾
Loosen the lowest plastic ring.
¾
Insert the waste tube in one of the two remaining holes.
¾
Fix the tube by sliding the plastic ring back to the tube.
¾
If necessary lower the upper plastic ring.
¾
Check if the tube is locked securely.
¾
Repeat point 1 to 7 for the other small tube.
1 : plastic rings on small tube 3 : Top Waste Bottle Bracket
2 : big waste tube 4 : Top Waste Bottle
(Please refer to picture A mentioned below.)
Step 5 :
Connect the connector of the Waste Bottle Sensor. (Please refer to picture A mentioned below.)