MUTOH Falcon Outdoor Jr., Operation Instructions Manual, Page: 12 / 71

Falcon Outdoor Jr. – Operation Instructions
Page
12 PN: MAI-75039
Rev. 1.A – 07/26/05
Plot OK Step 1:
To enter the Menu system, press the [MENU] key.
* Menu * Command > Step 2:
The key contents change to the yellow section on the outside of the
control panel. Bring up the “Function” menu by pressing the
[Menu
up] key or [Menu Down] key.
* Menu * Function >
Step 3:
Press the [ENTER] key to enter the “Function” menu and shift to the
next level.
Step Adjustment : Change
Step 4:
Bring up the “Step Adjustment” item by pressing the [Menu up] key
or [Menu Down] key.
Step Adjustment : Clear
Step 5:
Press the [Value/+] or [Value/-] key to select “Change” or “Clear” and
press ENTER.
Step Adjustment : 0.00%
Step 6:
When pressing “Change”, enter the new value using the [VALUE/+] /
[VALUE/-] keys. Using the [MENU UP] / [MENU DOWN] keys,
you can select which digit you want to change. The value can be
changed in 0.01% increments.
Press
[ENTER] to confirm the new value.
Step Adjustment : Change
Step 7:
If no other items are to be changed, press the [BACK] key.
* Menu * Function >
Step 8:
Do not press any other keys for 3 minutes or press [BACK] key
Plot OK
Step 9:
The permanent ONLINE-status display is restored.
Note:
To find the optimum correction value for a certain media, you will need to go through
a series of test cycles. Preferably send to the plotter a small test image such as a
neutral grey square (between 50% and 70% Grey) and check the micro-banding as
described above. Make a note of your correction value for a certain media type, as
the required value will always be the same for this media type.
Note:
Before using this function, always perform a nozzle-check to see if all nozzles are firing
correctly. Nozzles which are not firing or misfiring might mislead you when entering
correction values.