MUTOH Falcon Outdoor Jr., Operation Instructions Manual, Page: 10 / 71

Falcon Outdoor Jr. – Operation Instructions
Page
10 PN: MAI-75039
Rev. 1.A – 07/26/05
QUICK START FOR SEH AND FALCON OUTDOOR PRINTERS
SEH PRINTSERVER AND INTERCON NETTOOLS SETUP AND DIAGNOSTIC
FEATURE (FILE DOWNLOAD)
TO INSTALL AN SEH BOX FOR ANY OF THE FALCON OUTDOOR SERIES
PRINTERS FOLLOW THESE STEPS.
1. DO NOT connect the SEH box to the printer at this time.
2. Put the CD in the computer, if ‘autorun’ starts then follow the info to install “English” and choose ‘Intercon
NetTools’ then Go to 9. If ‘autorun’ does not start then proceed.
3. Click – My Computer
4. Right click on the CD icon
5. Select “Explore” from menu
6. Double click on the “NetTool” folder
7. Double click on “Windows” folder
8. Double click “NetTool” Setup
9. Follow prompts to complete installation
•
Connect the SEH box ONLY to the network cable, DO NOT attach to the printer at this time. Use a
crossover cable if you are connecting directly to a computer. Use a standard cable if you are connecting
using a ‘switch’, ‘router’ or ‘hub’. Crossover direct connection should not be used for production work.
•
After completing 1 – 9 above, launch “InterCon – NetTools” from the desktop icon or find InterConTools
in your Programs folder.
•
Double click on the IP address (most likely all zeros). (Loading properties menu should open).
•
Select TCP/IP tab on the left.
•
Remove the ‘checks’ in the boxes from all items except ARP/Ping. Specifically DHCP.
•
‘Check’ the TCP/IP box and Enter your IP address and submask then click OK. A Gateway is not
required.
CAUTION: The IP address must match all three of the first 3 triads (sets of three numbers) and the only
difference is the last ‘triad’ where the printer is usually ‘1’ number different from the computer. All four triads
of the SUB NET mask must match exactly as well.
•
Select ‘rebuild’ on the Intercon NetTools menu. Verify the IP address line changes to your entered
address. The printer icon should show a red X through it.
•
Connect the SEH box to the printer LPT port. The red X should come off when the printer is powered
ON. Click the Refresh or Rebuild buttons to make it change if it doesn’t automatically refresh itself.
Notice that the SEH utility now shows the name of the printer.
Print server is now configured for your network and IP address.
•
Setup up your RIP software for the IP address of the SEH box.