Muratec MFX-2500, Operating Instructions Manual, Page: 18 / 103

1.10
Getting started
7
If you want to send more pages, proceed to step 8.
Otherwise, press
START
to start the transmission, and skip to step 9.
8
Place the next page, then press [Start] to start scanning.
To send any more pages, repeat this step.
Otherwise, press [Exit] to start the transmission, and skip to step 9.
9
Now, everything is up to the machines — yours and the one you’re dialling.
When it makes contact, your machine transmits the stored document from
memory.
Note: If you want to cancel a transmission while scanning the document,
press the
STOP
key.
If you want to cancel a transmission in progress, use the Review
Commands function. See “Review Commands, an introduction” page
1.11.
10
After transmission, the machine beeps and return to its standby mode.
Note: If the call fails, see “Redialling,” page 1.11.
Sending a fax using monitor/call or a handset
You also can fax a document using either the monitor speaker or the optional
handset to dial the call.
1
Place the document in the
ADF
.
Note: In this function, you cannot use the FBS glass.
2
Adjust resolution and contrast if necessary.
3
Obtain a dial tone, either by:
• Pressing
MONITOR
/
CALL
… or …
• Lifting the optional handset.
In either case, the
LCD
shows (see right):
4
Enter the fax number.
Also, enter access codes with the number, just as for a regular phone call.
5
When you hear fax tones from the remote unit, press
START
.
Note: If a person answers the phone, use the optional handset to tell that
person you’re trying to send a fax. When you hear fax tones, press
START
.
6
If you’re using an optional handset, hang up after pressing
START
.
7
After transmission, the machine beeps and returns to its standby mode.
Note: If the call fails and you used
MONITOR
/
CALL
to dial, press
MONITOR
/
CALL
to hang up. Or if you’ve pressed
START
to begin the fax
transmission, press
STOP
to end it.
Also see “Redialling manually,” next page, if the call fails.
Overseas transmission mode
This mode instructs your fax to compensate for the poor transmission
characteristics of some overseas telephone lines. To set overseas mode:
1
Enter the fax number using the numeric keypad.
2
Press
NEXT
until the [Overseas] is appeared.
Then press [Overseas].
Note: This feature automatically deactivates itself
following each dialling.