PWM 0
sends an IO_WRITE_PWM command to the module. A quick reply to either write command is
indicated by a
Successful
Status
. A
Failure Status
is usually caused by forgetting to install a jumper on
JP14. On the developer board, GPIO2 and 3 are connected to LEDs such that the LEDs light when the
module pin is set to 1.
Figure 8.6.20
The
CFG
tab allows the API CFG commands to be routed in UDP packets over the wireless link.
Figure 8.6.21
The WSN802G module must be awake in order to use the
IO Report
tab. To hold the module awake,
place a jumper on JP14, which is labeled ALWAYS ON or push and hold the WAKE IN button. Either a
single parameter can be selected for charting from the drop-down box in the lower left corner of the
IO
Report
tab, or all parameters can be selected for charting by clicking on the
Show All
button. The chart
area can be cleared and reset by clicking the
Clear
button.
©2009-2015 by Murata Electronics N.A., Inc.
HN-210D/X, HN-214 D/X Rev. 2.0 01-16-15
Page 85 of 101
www.murata.com
