AdHoc_Channel
- - this parameter sets the channel for Ad Hoc operation.
AdHoc_AuthMode
- this parameter sets the authentication mode for Ad Hoc operation as follows:
0x00000001 - open authentication, allows connection to a WLAN with any type of authentication
0x00000002 - shared authentication, allows connection to a WLAN only with WEP shared
authentication; must be used to connect to a WEP shared WLAN
0x00000003 - automatic authentication, allows connection to a WLAN with any type of
authentication
0x00000004 - WPA authentication, allows connection to a WLAN with WPA/WPA2 802.1x
authentication; WPA2 is selected over WPA if both are present
0x00000005 - WPAPSK authentication, allows connection to a WLAN with WPA/WPA2
authentication; WPA2 is selected over WPA if both are present
0x00000007 - WPA2 authentication, allows connection to a WLAN with WPA2 802.1x authentication
0x00000008 - WPA2PSK authentication, allows connection to a WLAN with WPA2 PSK
authentication
AdHoc_EncryptionMode
- this parameter selects the Ad Hoc encryption mode as
follows:
0x00000001 - allows connection to a WLAN only with WEP encryption
0x00000004 - allows connection to a WLAN only with TKIP encryption, either unicast or group;
it connects if either unicast cipher or group cipher is TKIP
0x00000020 - allows connection to a WLAN only with CCMP encryption, either unicast or group;
it connects if either unicast cipher or group cipher is CCMP
0x00000080 - allows connection to a WLAN only with no encryption
0x000000A5 - allows connection to a WLAN with any of the above modes
Note that encryption mode 0x000000A5 is derived from logically ORing the values of the four encryption
modes above it. Any combination of ORed encryption modes are allowed.
AdHoc_PskPassphrase
- this parameter holds the PSK passphrase for Ad Hoc operation. This parameter
is read-only.
AdHoc_PskKey
- this parameter holds the PSK key for Ad Hoc operation. This parameter is read-only.
AdHoc_WepKeyId
- this parameter is holds WEP key ID for Ad Hoc operation. The range of this
parameter is 0 to 3. This parameter is write-only. Attempting to read a write-only SNMP parameter returns
an error.
AdHoc_WepKeyLength
- this parameter sets the WEP key length for Ad Hoc operation. The range of this
parameter is 0x00000005 to 0x0000000D (5 to 13). This parameter is write-only. Attempting to read a
write-only SNMP parameter returns an error.
AdHoc_WepKeyValue
- this parameter holds the WEP key ASCII string for Ad Hoc operation, 5 to 13
bytes. The number of bytes must match the
AdHoc_WepKeyLength
value. This parameter is write-only.
Attempting to read a write-only SNMP parameter returns an error.
©2009-2015 by Murata Electronics N.A., Inc.
HN-210D/X, HN-214 D/X Rev. 2.0 01-16-15
Page 62 of 101
www.murata.com
