Multitone RPR 551IS, Technical Manual

Page: 34 / 127

! !
RPR 550IS Series
TM1188 Issue 1 Page 2 - 14
WHEN CHARGING IS ENABLED, ONLY PAGERS WITH RECHARGEABLE BATTERIES
SHOULD BE INSERTED INTO THE ABSENCE/CHARGING RACK.
BATTERY CHANGING OR RECHARGING IS ONLY TO BE UNDERTAKEN IN
NON-HAZARDOUS AREAS. ONLY ABSENCE AND CHARGING RACKS A3RO AND
A3RP ARE TO BE USED WITH RPR 550IS PAGERS.
ABSENCE RACK REGISTRATION AND CHARGING
WARNINGS
CAUTION
DO NOT PRESS THE OFF BUTTON WHEN THE PAGER IS IN THE ABSENCE RACK
OR PROGRAMMING POCKET OR THE EEPROM MAY BECOME CORRUPTED.
48.
The three contacts at the base of the pager are used for absence, charging and
programming purposes. The pager contains a rack message which may be up to a
maximum of nine characters in length. The factory programmed default rack message
`absent' may be changed to a user name by using P648H programming software.
49. Insert the pager into a pocket within the rack. The following rack message appears on
the display when the pager recognises absence mode.
ABSENT or USER NAME
50. The pager is interrogated by the system and if a user number is associated with the
pager number, the user number is displayed as follows:
ABSENT 1234 or USER NAME 1234
51. If the interrogation is unsuccessful there are two possibilities:
a) If there is no contact between system and pager, the following display is shown:
ABSENT or USER NAME
b) If there is no user number associated with the pager number, the following display
is shown:
ABSENT ---- or USER NAME ----