Multitech CommPlete CC2400, System Installation And Quick Start Manual

Page: 92 / 113

System Installation and Quick Start Guide
92
If you selected the European PRI switch type, the Framing Format will
default to 72 Frame Multiframe. All other Framing Format options will
be ignored. Press ENTER to display the Error Correction menu.
Error Correction
1. Disabled
2. Enabled
Enter Selection (-(previous), q (uit), <2>:
Verify the error correction setting and press ENTER to accept the current
setting, or type the corresponding option number to choose a new
setting. Press ENTER to display the Call Distribution menu:
Call Distribution
1. First Available
2. Uniform Distribution
3. One to One
Enter Selection (-(previous), q(uit), <3>):
23. The Call Distribution options determine the method by which incoming
analog calls are distributed to modems on a PRI segment. One to One
will result in calls going to the modems according to the DS-0 that the
call comes in on. First available will result in calls going to the first
modem, starting with 3A, that is not in use. Uniform Distribution will
result in calls going to the first available modem, starting with the last
modem that was picked.
Type the number of the distribution method that you wish to use and
press E
NTER
. The following Set Carrier menu appears:
Set Carrier
1. PCM24/T1
2. PCM30/CEPT
Enter Selection (-(previous), q(uit), <1>):
24. Verify that the appropriate carrier option is selected and press ENTER,
or type the option number of the new setting and press ENTER. The
Active Channels screen appears:
Active Channels (-(previous), q (uit), <23>):
Type 30 and press ENTER.
Note: As you proceed with the individual device configurations that
follow, you will be brought through some of the same parameters that
were configured during the System Defaults Setup. In such steps, verify
that the options are correct and press E
NTER
to accept the defaults.
MR9600 Controller Setup
Note: as you configure the controller, make note of your settings on the
Site Information sheet.