Multitech CommPlete CC2400, System Installation And Quick Start Manual

Page: 48 / 113

System Installation and Quick Start Guide
48
Disconnect Timeout (sec) :11
Framing Format :DS1 AT&T Extended Super Frame (ESF)
Line Coding :Binary 8 Zero substitution (B8Zs)
FXS Signaling Options : E&M Immediate Start
Transmit Level :-0.0.db
Save changes and config the device? (<y>, n):
81. Type y to save your changes, or n to cancel them. The following option
appears:
Select a T1/E1 Card (<1B>, 5B, 9B, 13B, -(previous),
d(one)):
82. To configure another T1 card, type the device number of the T1 you want
to set up, and repeat steps 79-81. Otherwise, type d and press E
NTER
to
finish. The Device Specific Setup menu reappears:
Device Specific Setup
1. Controller Setup
2. Ras Setup
3. T1 Setup
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection (-(previous), q(uit), <4>): q
83. Type q and press E
NTER
to quit. The following message appears:
Save System Defaults? (<y>, n):
84. Type y and press E
NTER
to save the system defaults. If you have not
changed the Supervisor User ID and password, do so at the prompts.
The following messages appear:
Saving Defaults .... Done
Change the Supervisor user ID and password
Enter User ID:
Supervisor
Enter new password: **********
Repeat new password: **********
Security information updated
System will now be re-booted...
85. After the system reboots, the opening messages reappear:
Welcome to the Complete Communications Server Controller
(MR9600) Version 2.53 (Oct 25 2000 09:26:20) -- 10/25/2000
11:00 am
Press any key to start system manually... starting .... done
Username: supervisor
Password: **********
86. At the Username prompt, type supervisor and press E
NTER
. When the
Password prompt appears, type your password and press E
NTER
. The
following prompt appears:
[0] A:\ #