![background image](http://html1.mh-extra.com/html/multiquip/rammax-rx1575/rammax-rx1575_operation-manual_1855337026.webp)
PAGE 26 — RX1575 SERIES TRENCH ROLLER • OPERATION MANUAL — REV. #0 (04/28/15)
40
Rammax 1575
12
3004
7
| 21
.06
.201
3
Pre-heating
The pre-heating time lasts about 6 s. The
pre-heating indicator lamp
extinguishes
when the engine is started.
Shutdown bar
The
shutdown bar indicator lamp
remains lit as long as the shutdown bar is actu-
ated.
1
Check whether the shutdown bar has been released.
2
Release the shutdown bar.
5.1.3
LED error display on the display unit
Error display
Tab. 5-1 Error display (tilt switch)
NOTE
For safety reasons, as soon as the roller tips over, the ignition is also shut off.
The machine controller is equipped with an inclination sensor. It triggers as of
an angle of 45°. In this case, the engine shuts itself off automatically. The ma-
chine cannot be started as long as the inclination sensor remains triggered.
If the machine has tipped over, it is possible for engine oil to enter the combus-
tion area. If the machine is started after it has been righted, engine damage is
possible.
• Set the machine upright. Do not start the engine under any circumstances.
• Inform the service workshop.
Tab. 5-2 Error and shutdown bar display
NOTE
Bear in mind the priority of the displays: First is the tilt switch, then “Wait” and
last, the status error transistor.
Display
Cause
Remedy
Error lights up
The tilt switch has been triggered.
The roller is at an angle of more
than about 45° or has tipped over.
Set the machine upright.
Display
Cause
Remedy
Error lights up
A switching transistor signals
a status error. This means
that, for example, a short cir-
cuit or a cable break has
been detected.
Check the cable for a short cir-
cuit or cable break.
Error and shutdown
bar light up in unison
The machine controller is
waiting for both the inputs “Oil
pressure” and “Lima” to be at
the rest position.
Check the oil pressure and lima
outputs.
(OPTIONAL)
OPERATING AND DISPLAY ELEMENTS