MULTIQUIP GLOBUG GBX24B, Operation Manual, Page: 24 / 68

PAGE 24 —GBX24S/GBX24B LIGHT TOWER • OPERATION AND PARTS MANUAL — REV. #0 (05/30/19)
SETUP
PREPARATION
1. Place the light tower in an area free of dirt and debris
with enough clearance as not to interfere with any
overhead obstructions. Make sure it is on secure level
ground with chock blocks underneath each wheel to
prevent the light tower from rolling.
2. Extend all the outriggers by pulling the locking pin on
the outriggers and hold while sliding out the outriggers
assembly (Figure 8).
Figure 8. Pulling the Locking Pin
3. As soon as the locking pin clears the travel position
hole, release pin and continue sliding out the outrigger.
When outrigger is in the extended position, make sure
pin snaps into the outrigger locking hole (Figure 9).
Figure 9. Extending Outriggers
DANGER
ALWAYS make sure the area above light tower is
open and clear of overhead power lines and other
obstructions. The tower extends in excess of 23 ft.
(7 meters). Contact with overhead power lines or other
obstructions could result in equipment damage, serious
injury or death!
LOCKING PIN
LOCKING PIN
OUTRIGGER
4. After extending all outriggers, rotate all trailer
jackstands into the foot-down position. Turn the crank
handle on the jackstands clockwise to lower them to
the level of the light tower.
Figure 10. Lowering the Jackstands
CHANGING LAMP DIRECTION
The mast can be rotated to change the direction that the
lamps are facing. The lamps can also be rotated individually.
Rotating the Mast
5. With the mast in full vertical position, unscrew the mast
locking knob to release the mast for rotation (Figure 11).
Figure 11. Rotating the Mast
6. Grab the mast handles and rotate the mast until the
lamps are facing the desired direction.
7. Tigthen the mast locking knob to lock the mast in place.
CRANK HANDLE
JACK STAND
MAST
HANDLE
MAST
LOCKING KNOB