![background image](http://html1.mh-extra.com/html/multiquip/globug-gb4000/globug-gb4000_operation-and-parts-manual_1855424019.webp)
GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL —REV. #1 (02/25/14) —PAGE
PREPARATION
POWER DISCONNECTION
SETUP
1. Place the light tower in an area free of dirt and debris
with enough clearance as not to interfere with any
overhead obstructions. Make sure it is on secure level
ground with chock blocks underneath each wheel to
prevent the light tower fromrolling.
DANGER
1. For LT12Dlight towers, disconnect thenegativecable
(black) from battery. See Figure 5.
DISCONNECT
NEGATIVE
BATTERY CABLE
ALWAYS
make sure the area above
light tower is open and clear of
overhead power lines and other
obstructions. The tower extends in
excess of 30 ft. (9 meters). Contact
with overhead power lines or other
obstructionscouldresultinequipment
damage, serious injury or death!
2. If the light tower is in the deployed position, placethe
tower mast into the cradle support (stowed position).
See Figure 4. Make sure cradle lock/release pin has
been inserted and the mast is locked.
STOWED
POSITION
Figure 5. Disconnecting Battery
2. For MLTserieslight towersdisconnect the4-pinpower
cable(Figure6) fromthe120VACtwist-lockreceptacle
on the front panel of the generator.
MLT
LIGHT TOWER
Figure 4. Light Tower in Stowed Position
DISCONNECT
4-PIN POWER
CABLE
TO BALLAST
COMPARTMENT
Figure 6. MLT Power Cable Removal
MAST
LOCK
NOTICE
The newlamp adapter plate requires no existing lamp
removal for installation. All lamps can remain in place
during installation of the adapter plate.
NOTICE
Only mount the GB4000 on Light Towers that are
equipped with one of the following ballasts:
• UNIVERSAL LIGHTING TECHNOLOGIES INC:
M1000120AC5M
• PHILIPS LIGHTINGELECTRONICNA : 71A-6592.