22
Part Number: 9290312 May/17/2016
Maintenance
Section 4
9. Open both the (plain and nitrogen coffee) taps.
10. Press and hold the Prime/Clean button until the LED around
the button turns on to place the unit into cleaning mode.
• Cleaning button will illuminate blue in color around the
button indicating unit is in cleaning mode.
• Button Illuminations and modes:
• To abort cleaning mode press and hold the cleaning
button until the LED around the Prime/Clean button
turns OFF. This exits cleaning mode into keg change
mode and LED will no longer be illuminated.
NOTE: Priming is required after aborting cleaning or clearing an
error.
See “Priming the System” on page 16
Imprtant
If cleaning mode is accidentally aborted or aborted because
of an issue/reason, then the cleaning process will need to
start over from the beginning after a two (2) minute wait.
NOTE: If an error is encountered at any time during cleaning
process the cleaning button will blink ON/OFF rapidly indicating
unit is in an error state and cleaning process has stopped.
To exit error state close both taps then press and hold the
Clean/Prime button until the LED around the button turns OFF
to clear error state and exit into keg change mode.
Once error state is cleared the cleaning process can be started
over after a two (2) minute wait.
NOTE: Priming is required after aborting cleaning or clearing an
error.
See “Priming the System” on page 16
11. Unit will automatically run through cleaning process.
12. Towards the end of cleaning process there will be a system
purge process and once bubbles are seen coming from five
(5) gallon bucket, close plain coffee tap.
13. Once cleaning process is complete the LED will not be
illuminated, which indicates cleaning is complete and both
product taps should be closed.
14. Disconnect cleaning solution keg and set aside.
15. Mix proper concentration of approved sanitizing solution (400
ppm Quat concentrate) in the second three (3) gallon keg.
16. Connect the inlet and outlet keg connectors of unit to
sanitizing solution keg.
17. Press and release the Prime/Clean button to prime the
system with cleaning solution. The LED around the
button will flash ON then OFF.
18. Empty the five (5) gallon bucket and place ends of clear
nozzle drain hoses back into bucket.
19. Repeat Step 9 and 10, again unit will automatically run
through sanitizing process.
