3.Junior User Guidebook
Warning:
To avoid electric shock, always keep your finger behind the safety guard
ring of the probe during the operation.
To protect you from suffering from the electric shock, do not touch any
metal part of the probe tip when it is connected to the power supply.
Before making any measurements, always connect the probe to the
instrument and connect the ground terminal to the earth.
How to Implement Self-calibration
The self-calibration application can make the oscilloscope reach the optimum condition
rapidly to obtain the most accurate measurement value. You can carry out this application
program at any time. This program must be executed whenever the change of ambient
temperature is 5
℃
or over.
Before performing a self-calibration, disconnect all probes or wires from the
input connector. Push the
Utility
button, select
Function
in the bottom menu, select
Adjust
. in the left menu, select
Self Cal
in the bottom menu; run the program after
everything is ready.
Introduction to the Vertical System
As shown in
, there are a few of buttons and knobs in
Vertical Controls
.
The following practices will gradually direct you to be familiar with the using
of the vertical setting.
Figure 3-11 Vertical Control Zone
1. Use the
Vertical Position
knob to show the signal in the center of the waveform
window. The
Vertical Position
knob functions the regulating of the vertical
display position of the signal. Thus, when the
Vertical Position
knob is rotated, the
pointer
of the earth datum point of the channel is directed to move up and down following
the waveform.
14
Summary of Contents for MP720105
Page 1: ...i Digital Storage Oscilloscope Model MP720105 MP72016 MP72107...
Page 40: ...4 Advanced User Guidebook Figure 4 2 Rectangle window Figure 4 3 Blackman window 35...
Page 41: ...4 Advanced User Guidebook Figure 4 4 Hanning window Figure 4 5 Kaiser window 36...
Page 68: ...4 Advanced User Guidebook Sine x x interpolation Linear interpolation 63...
