Multi-Tech MultiModem ISIHI-2S, Manual

Page: 104 / 186

104 MultiModemISI Hybrid Series, ISIHI-2S
Chapter 5—TERMINAL ADAPTER AT Commands, S-Registers, Result Codes
T
erminal Adapter
Dn Dial
Values: string of up to 25 characters
Default: none
Causes TA to dial a telephone number (e.g., ATD785-3500 <cr>).
Hn Hang Up
Values: n = 0 or 1
Default:
H0
Forces TA to go off-hook (to take control of the telephone line) or to go on-hook (hang
up). Since the TA goes off-hook automatically when it dials,
H command normally is used
only to hang up. To hang up, you must first escape to command mode (+++AT <cr>),
then type ATH (or ATH0) <cr>. Or, include the hang up command in the escape
sequence: +++ATH <cr>.
H0 Go on-hook (hang up).
H1
Go off-hook.
In Display Product Information
Values: n = 0, 1, and 2
Default: none
Displays the following TA product information:
I0 Product ID (e.g., 247)
I1 Firmware version number (e.g., 1.00)
I2 Model number
O Return Online
Values: none
Default: none
Returns TA to online mode from the online command mode. When TA makes a data
connection, it enters online data mode. The TA typically remains in this mode until it
receives an escape sequence or until the call ends. When it detects an escape
sequence, the TA enters online command mode, where it can accept AT commands while
retaining the online connection. To return the TA to online mode from the online
command mode, enter the command
ATO and press ENTER.
@CONFIG Start ConfigMenu
Values: none
Default: none
Starts TA’s internal configuration utility, which you can then use to customize the TA’s
configuration for your particular application. You must enter the command while in your
communication program’s terminal mode.