Multi-Tech MultiModem ISIHI-2S, Manual

Page: 155 / 186

MultiModemISI Hybrid Series, ISIHI-2S 155
Appendix
S r? Read Register Value
r = 0–810-11,28, 35, 37, 42-43, or 89
Read value of S-register
r and display value in 3-digit decimal form.
&S n Data Set Ready Control
n = 0 or 1
&S0
Force DSR high (on)
&S1 Let DSR follow CD
T Tone-Dial
Value in dialing command
Modem tone-dials numbers following the T.
&T
n
Self-Test Commands
n = 0, 1, 3, or 6
&T0
Stop any test currently in progress
&T1 Local analog loop test
&T3 Local digital loopback test
&T6 Remote digital loopback test
\T n Inactivity Timer
n = 0
\T0
Disable inactivity timer
V Switch to Speakerphone Mode
Value in dialing command
Switches to speakerphone mode and dials the following number. Use ATH command to hang up.
V
n
Result Codes (Verbose/Terse)
n = 0 or 1
V0
Result codes sent as digits (terse response)
V1 Result codes sent as words (verbose response)
&V View Current Configuration
Display the active modem settings
\V n Protocol Result Code
n = 0 or 1
\V0
Do not append protocol result code to DCE speed.
\V1 Append protocol result code to DCE speed
W Wait for New Dial Tone
Value in dialing command
Causes modem to wait for new dial tone. (X2, X4, X5, X6, or X7 must be selected.)
&W n Store Configuration
n = 0
&W0 Store current settings in NVRAM; modem will load these at power-on or with the ATZ
command instead of reading factory ROM defaults.
X n Result Codes and Call Progress Selection
n = 0–7
X0
Basic result codes (CONNECT
only); does not look for dial tone or busy
X1 Extended result codes (w/ CONNECT 1200
, CONNECT 2400, etc.); does not look for dial
tone or busy signal
X2 Extended result codes with NO DIAL TONE; does not look for busy signal
X3 Extended result codes with BUSY; does not look for dial tone
X4 Extended result codes with NO DIAL TONE and BUSY
X5 Extended result codes with NO DIAL TONE and BUSY
X6 Extended result codes with NO DIAL TONE and BUSY
X7 Basic result codes with NO DIAL TONE and BUSY