Multi-Tech MultiModem ISIHI-2S, Manual

Page: 103 / 186

MultliModemISI Hybrid Series, ISIHI-2S 103
Chapter 5—TERMINAL ADAPTER AT Commands, S-Registers, Result Codes
T
erminal Adapter
%E4 Disable OK response to +++
%E5 Enable OK response to +++
%E1 %E5 ++ method and OK response to +++
%E3 %E5 ++ or <BREAK> method and OK response to +++
@P3=n Parity at Power-Up
Values: n = 0–4
Default:
@P3=4 (None)
Use only to set the type of parity the TA uses when turned on. Once the TA receives an
AT command from the computer, it automatically adjusts to parity the computer is using.
@P3=0 Odd
@P3=1 Even
@P3=2 Mark
@P3=3 Space
@P3=4
None
@P4=n Data Bits
Values: n = 7 or 8
Default:
@P4=8 (8 data bits)
Use only to set the number of data bits the TA uses when turned on. Once the TA
receives an AT command from the computer, it automatically adjusts to number of data
bits the computer is using.
@P4=7
7 data bits
@P4=8 8 data bits
@P6=n Stop Bits
Values: n = 1 or 2
Default:
@P6=1 (1 stop bit)
Use this command only to set the number of stop bits the TA uses when turned on. Once
the TA receives an AT command from the computer, it automatically adjusts to the
number of stop bits the computer is using.
@P6=1 1 stop bit
@P6=2 2 stop bits
Data Call Commands
Use these commands to make or configure data calls.
A Answer Call
Values: none
Default: none
Forces TA to answer an incoming call. To cause the TA to autoanswer, set register S0 to
a value higher than 0.