Multi-Tech MultiModem ISIHI-2S, Manual

Page: 16 / 186

16 MultiModemISI Hybrid Series, ISIHI-2S
Hardware Installation
Introduction
This chapter describes how to install the ISIHI-2S card into the ISA bus on your personal
computer. Hardware installation involves the following:
• Opening your PC
• Setting card configuration (determining I/O address DIP-switch setting and IRQ jumper
setting)
• Installing the card into the PC
Computer Requirements
• 386, 486, or Pentium®-based PC or compatible with ISA Bus Architecture
• Microsoft Windows 95, Windows NT 4.0, SCO Open Server version 5.0, or Novell
NetWare
• At least one floppy drive
• 800 blocks of hard disk space for UNIX, 100K bytes for Windows NT, 34K bytes for
Windows 95, and 50K bytes for Novell
Shipping Contents
• ISIHI-2S card
• Two RJ-45 ISDN cords
• ISIHI Driver Disk Set with ISDN TA Configuration Wizard
• Quick Start Guide
Safety Warnings
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jacks are specifically designed
for wet locations.
• Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There
may be a remote risk of electrical shock from lightning.
• Do not use the telephone to report a gas leak in the vicinity of that leak.
• Ports that are connected to other apparatus are defined as SELV. To ensure conformity
to EN 41003, ensure that these ports are only connected to the same type on the other
apparatus.