Multi-Tech MultiModem ISIHI-2S, Manual

Page: 108 / 186

108 MultiModemISI Hybrid Series, ISIHI-2S
Chapter 5—TERMINAL ADAPTER AT Commands, S-Registers, Result Codes
T
erminal Adapter
Terminal Adapter Result Codes
When the TA receives an AT command from the computer or terminal, it attempts to
execute the command, then sends a status message to the computer or terminal that
reports the result of the command. The TA provides you with several of these response
messages, or
result codes, which can be displayed on your monitor or intercepted and
used by your communications software. Using the
V command, you can select whether
the result codes are terse (numbers) or verbose (words).
The TA’s result codes are listed in the following table. Note that the speed of an ISDN
channel is always either 56 Kbps or 64 Kbps.
CONNECT messages indicate the speed
of the connection between the TA and your computer or terminal.
Terse Verbose
0 OK
1 CONNECT
1P CONNECT/PPP
1PC CONNECT/PPP COMPRESSED
1V CONNECT/V.120
1VC CONNECT/V.120 COMPRESSED
1X CONNECT/X.75
1XC CONECT/X.75 COMPRESSED
2 RING
3 NO CARRIER
4 ERROR
6 NO DIALTONE
7 BUSY
56 CONNECT 56000
56P CONNECT 56000/PPP
56PC CONNECT 56000/PPP COMPRESSED
56V CONNECT 56000/V.120
56VC CONNECT 56000/V.120 COMPRESSED
56X CONNECT 56000/X.75
56XC CONNECT 56000/X.75 COMPRESSED
64 CONNECT 64000
64P CONNECT 64000/PPP
64PC CONNECT 64000/PPP COMPRESSED
64V CONNECT 64000/V.120
64VC CONNECT 64000/V.120 COMPRESSED
64X CONNECT 64000/X.75
64XC CONNECT 64000/X.75 COMPRESSED
65 CONNECT MODEM