76
5. Completely loosen the jam nuts “E” in Figure-12 so that they slide off the threads. Use a 15/16” wrench (Fig-
ure-13).
6. Slide the cables ends completely out of the bracket, and set them off to the side (Figure-14).
Figure-13
Nut Removal
Parking Brake Cont.
4. For each cable, remove its clevis shown as “I” in Figure-10. It’s easiest to use a 7/16” wrench on the jam nut “J”
and use a pair of pliers to spin the clevis off (Figure-11).
Figure-11
Loosen Jam Nut
Figure-12
Clevis Removed
Figure-14
Cable Removed
7. For each cable, locate their front most end which is connected to the brake caliper, (1) per side of the Mudd-Ox.
Similar to the rearmost ends, there is a cotter pin and clevis pin shown as “G” and “H” in Figure-15 respectively.
Use a pair of needle nose pliers to remove the cotter pins, then push the clevis pins out (Figure-16).
Figure-15
Frontmost End
H
H
GG
Figure-16
Pin Removed
E
E
FF
