50
ModCon®75 Touch
•
The ModCon75 will display the following sensor faults:
o
+ LOC
o
Over-range
o
Quick under-range
o
Under-range
o
Sensor missing
o
Sensor End of Life
o
Calibration fault
o
Power Fail fault
o
Configuration reset
o
Span Calibration Fault
o
Zero Calibration Fault
o
Parameter Fault
o
Incompatible Sensor
o
Sensor Warning
•
All other faults are shown as General Fault
8.4 Remote I/O Editor Button:
(Optional: Requires Remote Relay Modules)
Figure 47. Remote Relay Editor Screen
Optional: Remote Relay units
•
A total of five remote relay units may be added to the Modbus network (see Appendix
C for additional details). Modbus ID numbers of the remote relay modules must be set
for ID#30, 31, 32, 33 or 34.
o
To modify any settings, verify the password lock/unlock graphic is unlocked.
Review instructions on page 37 to unlock password lock/unlock graphic
.
•
Each Remote Relay has five additional relays (Relay O0 thru Relay O4).
•
Relay O0 – Local Horn relay
•
Relay O1 thru Relay O4 can be setup for any combination of Zone relay output (Zone 1
thru Zone 9).
NOTE:
o
If Zone Alarms are programmed as Latch, one can silence the alarm at the
ModCon75 Touch (Silence Button), but the Zone alarm will not be cleared until the
unlatch input is initiated at the ModCon75 Touch Controller.