MSA ModCon 75, Instruction Manual, Page: 14 / 84

13
ModCon®75 Touch
Figure 3. ModCon75 Touch Controller Panel Cut-out—Front View
o
On the screw’s shank, place the following hardware in this order:
washer, ring terminal, second washer, spring, and nut as shown
in Figure 4.
Figure 4. Earth Assembly
•
Slide the HMI panel into the cutout, ensuring that the rubber seal is in place as shown
in Figure 5.
•
Push the four mounting brackets into their slots on the sides of the HMI panel as
shown in Figure 5.
•
Tighten the bracket screws against the HMI panel. Hold the brackets securely against
the unit while tightening the screws.