12
ModCon®75 Touch
Safety and Environmental Guideline
•
This is a general-purpose (GP) monitor and can be a source of ignition.
Install, locate, and operate only in an area where hazardous atmosphere
is not present and in accordance with all applicable codes.
•
Do not install in areas with.
o
excessive or conductive dust
o
corrosive or flammable gas
o
moisture or rain
o
excessive heat
o
regular impact shocks or excessive vibration.
•
Do not place in water or allow water to leak onto the controller.
•
Do not allow debris to fall inside the unit during installation.
•
Do not touch live wires.
•
Double-check all the wiring before turning ON the power supply.
•
Stay as far as possible from high-voltage cables and power equipment.
•
Allow a minimum of 0.4” of space for ventilation between the top and bottom edges of
the controller and the enclosure walls
.
•
Read and follow all instructions, warnings, and cautions pertaining to this controller.
FAILURE TO FOLLOW THESE WARNINGS CAN RESULT INSERIOUS PERSONAL
INJURY OR LOSS OF LIFE.
Mounting
NOTE:
o
The mounting panel cannot be more than 0.2” thick.
•
To maximize system performance, avoid electromagnetic
interference by.
o
mounting the controller on a metal panel
o
earthing the ModCon75 Touch Controller according to Figure 4.
•
Make a panel cutout for your ModCon75 Touch Controller.
o
See Figure 3 for cutout dimensions.
•
If you are mounting the controller on a metal panel, earth the power supply.
o
Bore a hole (Figure 4).
o
Scrape the panel paint away from the contact area to ensure a conductive
connection.
o
Ensure proper ingress protection per applicable codes and standards.
o
Drive the screw into the hole.