MS ENERGY e21, Instruction Manual

Page: 285 / 332

ENG
4
7.
Do not turn off the motor power while riding the scooter.
8.
Do not try to ride
:

Over a gap of more than 3 cm.
This may cause injury to the rider
or damage the vehicle.

When riding on the rough or
bumpy road, please slow down
the electric scooter or stop riding
the vehicle.

On slippery surfaces such as oil or ice.

In the weather conditions with the temperature below 0°C.

Over the water to avoid damage to the electrical parts of the
vehicle.

In adverse weather conditions like rain, snow or wind storm to
prevent an accident and damage or malfunctions caused by
water or moisture. If riding in these conditions, never exceed
the speed of 10 km/h.
1. Do not use or move the Electric Scooter while the battery charger is
connected. If you do, it may cause the power cable, the battery
charger and/or the charging port damage.
2. Do not ride the E‐Scooter if there is a fault with the battery or any
component of the power system. Otherwise you may lose control
and suffer serious injury.
3. Be sure to check the remaining battery capacity before riding at
night. The light powered by the battery pack will go off soon after
the remaining battery capacity decreases to the point where riding
with assisted power is no longer possible. Riding without a light may
increase the risk of injury.
4. It is recommendable to charge the battery at 30‐70%
of the total capacity of the battery. Avoid totally
discharge your scooter’s battery to zero charge before
charging.
5. Do not modify or remove any parts. Do not install non‐original parts
or accessories. If you do, they may damage the product, cause a
fault or increase the risk of being injured.
6.
Preparations before riding
:
Wear your helmet, gloves and other
protective gear before riding to protect yourself from damage in
case of an accident.
Each time, check the condition of your scooter to make sure all
parts are tight. If necessary, be sure to tighten all loose parts