DCA220SSJU4F 60 HZ GENERATOR• OPERATION MANUAL — REV. #3 (02/10/17) — PAGE 71
kvar PID
kvar Ramp Status
kvar Setpoint
kW Error
kW Load Percent
kW PID
kW Ramp Status
Load Share Active
Logic Control Relays: LCR 1-64
LS Input
Mains Base Load
Mains Total System kW Load
Next To Start
Next To Stop
Number of Units
Number of Units in Active Segment
Number of Units Online
Oil Pressure
PF Mode
PF Setpoint
Ramped Var Demand
Ramped Watt Demand
Rated kvar
Rated kW
Real Time Clock: Date
Real Time Clock: Time
Reserve Available
Speed Bias Output
Speed Error
Speed PID
Speed Source
System Load Bus: Frequency
System Load Bus: Total PF
System Load Bus: Total var
System Load Bus: Total Watt
System Load Bus: Average Current
System Load Bus: Average Voltage
System Generated kvar
System Generated kW
System Generated kW Percent
System Group Bus: Frequency
System Group Bus: Total PF
System Group Bus: Total var
System Group Bus: Total Watt
System Group Bus: Average Current
System Group Bus: Average Voltage
System Mains Bus: Frequency
System Mains Bus: Total PF
System Mains Bus: Total var
System Mains Bus: Total Watt
System Mains Bus: Average Current
System Mains Bus: Average Voltage
System Manager
System Online kvar Capacity
System Online kW Capacity
System Total kW Capacity
Total Fuel Used
Total Run Time
Var Demand
Var Mode
Volt Error
Volt PID
Voltage Bias Output
Watt Demand
Main Menu
Pressing the right arrow key while viewing the Overview screen opens the Main Menu screen. The Main
Menu screen options consist of Metering, Settings, and Summary. Metering screens primarily display
specific metering information. Settings screens primarily contain settings for configuring the
DGC-2020HD. The Summary screen consists of a one-line diagram of the system configuration, mains
fail transfer status, bus metering, and breaker command options.
Summary Screen
A one-line diagram, located at the top of the Summary screen, indicates system configuration and real
time breaker status. This one-line diagram is essentially the same as the one described in
Overview
Screen
above, except this diagram does not contain the shortcuts.
Mains fail transfer status is displayed just below the diagram. Mains fail transfer timers can be viewed by
selecting Mains fail transfer status (top line) and pressing the right arrow key. Press the left arrow key to
return to the Summary screen. See
Metering
chapter for details.
Metering of voltage, current, frequency, power, and power factor for the generator bus is displayed. Only
metered voltage and frequency for Bus 1 and Bus 2 are displayed.
Breakers in the system are listed at the bottom of the Summary screen. To send an open or close request
to a breaker in the system, move the cursor to the desired breaker in the list and press Edit. Press the up
BASLER DGC-2020 PROGRAMMING APPENDIX (OPTION)