DCA220SSJU4F 60 HZ GENERATOR• OPERATION MANUAL — REV. #3 (02/10/17) — PAGE 73
BASLER DGC-2020 PROGRAMMING APPENDIX (OPTION)
o
PF Mode
o
Op Baseload Level
o
Op kvar Setpoint
o
Op PF Setpoint
•
Run Statistics
o
Cumulative
o
Session
•
Status
o
Status
o
Bus Condition
o
IO Module Connected
o
Run Request
o
Mains Power Control
•
Inputs
o
Contact Inputs
o
Analog Input Values
o
Remote Contact Inputs
o
Remote Analog Input Values
o
Logic Control Relays
o
Remote System Manager Inputs
o
Broadcast Logic
•
Outputs
o
Contact Outputs
o
Analog Outputs
o
Configurable Elements
o
Remote Contact Outputs
o
Remote Analog Outputs
•
Configurable Protection
o
Configurable Protection 1 to Configurable Protection 32
•
Alarms
•
Pre-Alarms
•
Event Log
o
Show Log
o
Reset
•
J1939 ECU
o
J1939 Data (Visible when CAN Bus 2 ECU Support is enabled.)
o
J1939 Engine Config (Visible when CAN Bus 2 ECU Support is enabled.)
o
DTC Active Data (Visible when CAN Bus 2 ECU and DTC Support are enabled.)
o
DTC Previous Data (Visible when CAN Bus 2 ECU and DTC Support are enabled.)
•
MTU
o
MTU Fault Codes (Visible when selected ECU type is MTU MDEC, MTU ADEC, MTU
ECU7/8, and MTU Smart Connect.)
MTU Status (Visible when selected ECU type is MTU MDEC, MTU ADEC, MTU ECU7/8,
and MTU Smart Connect.)
•
System Status
o
System Breaker Status
o
System Mains Bus
o
System Group Bus
o
System Load Bus
o
Power Breaker Sum
•
Real Time Clock
•
Gen Network Status
o
Units
o
Act Seg Units
o
Units Online
o
Sys Online kW Cap