15
GB
4.
Place a suitable mixer (A1), (A2) or (A3) on the mixer drive shaft with pin (8). Push the mixer
base onto the pin and then turn clockwise until the lock clicks. To disassemble the given
mixer, push it again, while turning counter-clockwise. The assembly and disassembly pro-
cedure is identical for all mixers.
5.
Lower the food processor head (2) to working position. The cover lock will click distinc-
tively.
6.
Bowl (A4), bowl cover (A5) and mixers (A1)(A2)(A3) can be disassembled only after moving
the head (2) to open position.
BLENDER (B) ASSEMBLY
1.
Install the bowl cover (A5) and bowl (A4).
2.
Remove the blender mounting socket cap (11) from the food processor head (2).
3.
Turn the blender jug (B2) so that the base opening is pointed upwards. Place a rubber seal
on the glass surface and then place a cutter on the seal so that the blades are inside the jug.
Put the jug base ring (B1) onto the seal and cutter, and turn it clockwise, while ensuring that
the thread is aligned properly.
4.
Place the jug base ring (B1) and the jug (B2) in the blender mounting socket (10) so that the
tabs in the ring enter their places in the socket and then gently turn the jug clockwise until
the lock clicks.
5.
To remove the blender jug with the ring, turn it counter-clockwise.
MEAT MINCER (C) ASSEMBLY
1.
Install the bowl cover (A5) and bowl (A4).
2.
Remove the meat mincer/multi-purpose attachment mounting socket cap (12) from the
food processor head (2).
3.
Place the mincing chamber (C7) in the meat mincer mounting socket (9) so that the meat
input element is turned upwards, but inclined approx. 30° from the vertical position, and
then turn the element to the vertical position so that the lock clicks. The lock will click only
if the chamber is properly seated in the socket.
4.
Install the screw (C6) inside the mincing chamber (C7) so that the screw gear is inside the
chamber.
5.
Attach a cutter (C5) to the cuboid screw end (C6) so that the cutter base is pointed to inside
of the mincing chamber (C7) and cutter blades to the outside.
6.
Place a sieve (C2)(C3)(C4), depending on the desired mesh diameter, on the roller end of the
screw and then screw the mincing chamber nut (C1) onto the chamber.
7.
Place the tray (C8) on the mincing chamber and attach in an appropriate position.
8.
To disassemble the meat mincer, reverse the described assembly procedure, but to release
the mincer chamber lock (C7) from the socket (9), use the button (13).
MIXER (A) — GENERAL NOTES AND USING THE APPLIANCE
GENERAL NOTES
1.
When using the planetary mixer, its tool revolves in a complex movement: around its axis
and along the bowl perimeter at the same time. Thus, in one revolution, the mixer works
MRK-15_instrukcja_v04.indd 15
20.11.2018 12:02:39