VPort D361
Getting Started
2-11
Wall Mounting (Optional)
For some applications, you will find it convenient to mount the VPort D361 on the wall, as shown in the
diagrams below.
STEP 1:
Remove the aluminum DIN-Rail attachment plate from the VPort 351, and then attach the wall mounting
plates, as shown in the diagrams below.
STEP 2:
Mounting the VPort D361 on the wall requires 4 screws. Use the VPort D361, with wall
mount plates attached, as a guide to mark the correct locations of the 4 screws. The
heads of the screws should be less than 6.0 mm in diameter, and the shafts should be
less than 3.5 mm in diameter, as shown in the figure at the right.
Do not screw the screws in all the way—leave a space of about 2 mm to allow room for
sliding the wall mount panel between the wall and the screws.
NOTE
Test the screw head and shank size by inserting the screw into one of the keyhole shaped apertures of the wall
mounting plates before it is screwed into the wall.
STEP 3:
Once the screws are fixed in the wall, insert the four screw heads through the
large parts of the keyhole-shaped apertures, and then slide the VPort D361
downwards, as indicated in the figure. Tighten the four screws for added
stability.
Wiring Requirements
ATTENTION
Safety First!
Be sure to disconnect the power cord before installing and/or wiring your Moxa VPort D361.
Calculate the maximum possible current in each power wire and common wire. Observe all electrical codes
dictating the maximum current allowable for each wire size.
If the current goes above the maximum ratings, the wiring could overheat, causing serious damage to your
equipment.
