NPort W2150A-W4/W2250A-W4 Series User Manual
79
TCP alive check time
Default
7 min
Options
0 to 99 min
Description
This field specifies how long the NPort will wait for a response to “keep-alive” packets
before closing the TCP connection. The NPort checks connection status by sending periodic
“keep-alive” packets.
0: The TCP connection will remain open even if there is no response to the “keep-alive”
packets.
1 to 99: If the remote host does not respond to the packet within the specified time, the
NPort will force the existing TCP connection to close.
Destination address
Default
Options
IP address and port (e.g., “192.168.1.1” and “4001”)
Description
This field specifies the IP address for the NPort at the opposite end of the Pair Connection,
and the TCP port number for communication with the serial port. The port number must
match with that serial port’s TCP port setting.
TCP port
Default
4001
Options
Description
This field specifies the TCP port to use for communication with the attached serial device.
The serial port at the opposite end of the Pair Connection must use this port number to
establish the connection.
Settings for Ethernet Modem Mode
When
Application
is set to
Ethernet Modem Mode
, the NPort will accept AT commands such as “ATD
192.127.168.1:4001” from the serial port. A TCP connection will then be requested from the specified
remote Ethernet Modem or PC. When the remote unit accepts this TCP connection, the NPort will return the
“
CONNECT
{
baudrate
}” signal to the serial port and will then enter data mode. Please refer to Appendix C
for details on Ethernet modem commands.
