Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
43
Check Period
Setting
Description
Factory Default
5 to 300
Enter maximum time allowed for each IP checking cycle.
10
No Response Action
Setting
Description
Factory Default
No Action
The PSE has no action on the PD
No Action
Reboot PD
The PSE reboots the PD after the PD Failure Check
Power Off PD
The PSE powers off the PD after the PD Failure Check
PoE Timetabling
Powered devices usually do not need to be running 24
hours a day, 7 days a week. The PoE Ethernet switch
provides a PoE timetabling mechanism that lets users
economize the system’s power burden by setting a
flexible working schedule for each PoE port.
Port
Setting
Description
Factory Default
Port
Select which port you would like to configure.
Port 1
Enable
Setting
Description
Factory Default
Checked
Enables the PoE function of the port for the defined time
period.
Unchecked
Unchecked
Enables the PoE function of the port all the time.
MON, TUE, WED, THU, FRI, SAT, SUN
Setting
Description
Factory Default
Checked
Select those days on which you would like the port to be
enabled (you will then be able to modify the StartTime and
EndTime)
Disable
Unchecked
The port will not provide PoE power on days that are not
check marked.
Start/End Time
Setting
Description
Factory Default
Configured time
period
Enter the hour of the day the configuration will be enabled,
and the hour of the day the configuration will be disabled.
0 to 24
PoE Warning Event Settings
Since industrial Ethernet devices are often located at the endpoints of a system, these devices do not
always know what is happening elsewhere on the network. This means that a PoE port connected to a PD
must provide system administrators with real-time alarm messages. Even when control engineers are out of
the control room for an extended period of time, they can still be informed of the status of the PD almost
instantaneously when exceptions occur. The PoE Ethernet switch supports different methods for warning
engineers automatically, including SNMP trap, email, and relay output. It also supports two digital inputs to
integrate sensors into your system to automate alarms using email and relay output. The PoE warning event
settings are on the System Event Settings page.
