13
Note:
Before switching the sauna on check and test connections of the CON-
TROL BOX, the HEATERS, the MP3 PLAYER/RADIO, the TEMPERATURE SEN-
SOR etc. and make sure the electrical power parameters and frequency cor-
respond to the value required for your sauna. Make sure you have sufficient
power input available and then switch on the sauna.
Connection
Plug the fork into the appropriate socket.
Power up
Switch the sauna on with the POWER button in the control panel on the
inside or the outside wall of your sauna. The power LED control (POWER) be-
low the display will illuminate and the sauna will start heating to the present
temperature and for the preset time.
You can switch the sauna off again with the POWER button. The power will be
disconnected and all lights will go off.
Heating Time Settings
With the sauna on you can use the + and - (Time) buttons to increase or
decrease the sauna heating time. One depression of the button will increase/
decrease the time by 1 minute. Pressing and holding the button will change
the value in the quick mode. If the setting button is not pressed for the next 5
seconds the value will stop flashing and the set time will be saved.
The set time will be counted down by minute during sauna use. When the re-
maining countdown reaches 5 minutes the unit will release a warning acoustic
signal. Now you can set new sauna time. If you do not make a new time setting
the sauna will continue working and when the countdown reaches 0 minutes
the system will switch off automatically.
Temperature display switching between °C and °F
With the sauna on pressing this button will switch between °C/°F tem-
perature values on the TEMPERATURE DISPLAY.
Heating Temperature Settings
With the sauna on you can use the + and - (Temperature) buttons to in-
crease or decrease the sauna heating temperature. One depression of the but-
ton will increase/decrease the temperature by 1 degree. Pressing and holding
the button will change the value in the quick mode. This value will be the
sauna temperature setpoint. After 5 seconds of the setting button inactivity
the value will stop flashing, the set temperature will be saved and the display
will show the current temperature inside the sauna.
Note:
Ambient tempera-
Sauna Control and Operation
1
2
3
4
5
