MOTORVAC.COM
LOW
VEHICLE
FLUID
LOW
CLEAN
FLUID
START ENGINE
STOP ENGINE
COMPLETE
SERVICE IN
PROGRESS
STOP
DRAIN
MODE
FILL
EMPTY
WASTE
TransTech lV+
MANUAL
DIPSTICK
INLINE
START /
RESUME
FLUID EXCHANGE
Error Alerts
The TransTech IV+ has been designed to stop the service and alert the operator in certain instances if the
unit is not functioning properly. There are 2 different notifications, one that occurs while draining and the
other while the unit is filling. See below for details.
Fig.1
[email protected] www.motorvac.com
Alert
Notification
Cause
Hardware
Troubleshooting
steps
Recovery
Fill
Error
see
Fig. 1
The alarm sounds.
The following LEDs
flash: INLINE,
DIPSTICK, MANUAL
FILL.
There is a hardware or
software problem that
has caused the unit
to lose track of how
much fluid is in the
Clean Tank.
This alert prevents the
unit from overfilling the
transmission if there
is a problem with the
fluid level sensing
system.
Flow direction switch
is in position B for
dipstick service
Empty the Clean ATF
tank on the TransTech
IV+ before attempting
another exchange.
Note: Do not leave oil
standing above the 0
line of the clean tank
for extended periods
of time. This may
cause the unit to lose
track of fluid levels.
Ensure flow direction
switch is in position
A for dipsticks
service.
Press
STOP
button to
silence the buzzer.
Due to the probability
of an overfill condition,
the unit cannot recover
from this error.
Reset the unit to
attempt further
operation.
15
