Motorola MVME2603-1121A, Installation And Use Manual

Page: 61 / 210

Hardware Preparation and Installation
1-45
1
!
Warning
Dangerous voltages, capable of causing death, are
present in this equipment. Use extreme caution when
handling, testing, and adjusting.
3. Remove the filler panel(s) from the appropriate card slot(s) at
the front or rear of the chassis. (You may need to shift other
modules in the chassis to allow space for the MVME712M,
which has a double-wide front panel.)
4. Attach the P2 adapter board to the P2 backplane connector at
the slot occupied by the MVME2603/2604 VMEmodule.
5. Route the 64-conductor cable furnished with the MVME712M
from J2 on the P2 adapter board to J2 on the transition
module. Be sure to orient cable pin 1 with connector pin 1.
!
Caution
Avoid touching areas of integrated circuitry; static
discharge can damage these circuits
6. Secure the MVME712M in the chassis with the screws
provided, making good contact with the transverse mounting
rails to minimize RF emissions.
7. Referring to the userÕs manual for the MVME712M (listed in
the Related Documentation appendix), route the 50-conductor
cable to the internal or external SCSI devices as appropriate
to your system configuration. Be sure to orient cable pin 1
with connector pin 1.
Note The SCSI cabling can be configured in a number of
ways to accommodate various device and system
configurations.
Figure 1-22 shows a possible
configuration for use with internal SCSI devices. For
more detailed information on installing the P2 adapter