Motorola MVME2603-1121A, Installation And Use Manual

Page: 60 / 210

MVME712M Transition Module Installation
1-44
1
Note Some VME backplanes (e.g., those used in Motorola
ÔÔModular ChassisÕÕ systems) have an autojumpering
feature for automatic propagation of the IACK and BG
signals. Step 6 does not apply to such backplane
designs.
7. If necessary, install an MVME712M or MVME761 transition
module and cable it to the MVME2603/2604 as described in
the following sections of this document.
8. Replace the chassis or system cover(s), cable peripherals to
the panel connectors as appropriate, reconnect the system to
the AC or DC power source, and turn the equipment power on.
MVME712M Transition Module Installation
This section applies to MVME712M-compatible models of the
MVME2603/2604 VMEmodule. With the MVME2603/2604
installed, refer to
Figure 1-22 and proceed as follows to install an
MVME712M transition module:
1. Attach an ESD strap to your wrist. Attach the other end of the
ESD strap to the chassis as a ground. The ESD strap must be
secured to your wrist and to ground throughout the
procedure.
2. Perform an operating system shutdown. Turn the AC or DC
power off and remove the AC cord or DC power lines from
the system. Remove chassis or system cover(s) as necessary
for access to the VMEmodules.
!
Caution
MVME2600-2XXX (MVME712-compatible models) will
be damaged if they are mistakenly connected to the
MVME761 transition modules instead of the correct
MVME712 family of boards.
!
Caution
Inserting or removing modules with power applied
may result in damage to module components.