Motorola MVME2603-1121A, Installation And Use Manual

Page: 157 / 210

CNFG and ENV Commands
6-9
6
ROM Boot Direct Ending Address = FFFFFFFC?
The last location tested when PPCBug searches for a ROMboot
module. (Default = $FFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Network Auto Boot at power-up only [Y/N] = N?
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing
of network controller modules currently supported by PPCBug.
(Default = $00)
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing
of network controller modules currently supported by PPCBug.
(Default = $00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence will delay
before starting the boot. The purpose for the delay is to allow
you the option of stopping the boot by use of the
BREAK
key. The
time value is from 0-255 seconds. (Default = 5 seconds)
Network Auto Boot Configuration Parameters Offset (NVRAM) = 00001000?
The address where the network interface conÞguration
parameters are to be saved/retained in NVRAM; these
parameters are the necessary parameters to perform an
unattended network boot. A typical offset might be $1000, but
this value is application-speciÞc. (Default = $00001000)
Y
The Network Auto Boot (NETboot) function is
enabled.
N
The NETboot function is disabled. (Default)
Y
NETboot is attempted at power-up reset only.
N
NETboot is attempted at any reset. (Default)