Motorola MVME2603-1121A, Installation And Use Manual

Page: 20 / 210

Overview of Startup Procedure
1-4
1
In models of the MVME2603/2604 that are configured for
MVME712M I/O mode, the pin assignments of VMEbus connector
P2 are fully compatible with other transition modules of the
MVME712 series. In MVME761-compatible models, certain signals
are multiplexed through P2 for additional I/O capacity. Refer to P2
Signal Multiplexing in Chapter 3 for details.
Overview of Startup Procedure
The following table lists the things you will need to do before you
can use this board and tells where to find the information you need
to perform each step. Be sure to read this entire chapter, including
all Caution and Warning notes, before you begin.
Table 1-2. Startup Overview
What you need to do... Refer to... On page...
Unpack the hardware. Unpacking Instructions 1-5
ConÞgure the hardware by
setting jumpers on the boards
and transition modules. MVME2603/2604 Base Board Preparation and
MVME712M Transition Module Preparation or
MVME761 Transition Module Preparation
1-6 and
1-15 or 1-25
Ensure memory mezzanines
are properly installed on the
base board. RAM200 Memory Mezzanine Installation 1-33
Install the MVME2603/2604
VMEmodule in the chassis. MVME2603/2604 VMEmodule Installation 1-35
Install the transition module in
the chassis. MVME712M Transition Module Installation or
MVME761 Transition Module Installation
1-38
or 1-41
Connect a console terminal. System Considerations , MVME2603/2604
VMEmodule
1-46
Connect any other equipment
you will be using. Connector Pin Assignments 4-1
For more information on optional devices and
equipment, refer to the documentation provided
with the equipment.
Power up the system. Applying Power 2-1
Troubleshooting CPU Boards ; Solving Start-Up
Problems D-1