Wall mounting
27
EN
12. Wall mounting
IMPORTANT
Before you wall-mount your D1010, check that you are not drilling into any hidden wiring or pipes.
Before you drill, make sure the power and telephone line cables will reach the sockets.
1.
Use the following templates to mark the drilling locations.
• To wall-mount the base, drill two holes in the wall 4.5cm apart horizontally using an 8mm drill
bit.
• To wall-mount the charger, drill two holes in the wall 3.2cm apart horizontally using an 8mm drill
bit.
2.
Insert the wall plugs if necessary, then insert the screws leaving about 5mm protruding from
the wall on which to hang the phone.
3.
Pull the base/charger out of the stand and slot the holes on the back of the base over the
screw heads and gently pull the base/charger down to make sure it is securely in place.
