Canopy
T1/E1
Multiplexer
September
2004
T1/E1
Multiplexer
FPGA
Version
3.4
Page
37 of 73
10. At the
username
prompt, enter
admin
.
11. At the password prompt, enter your new password.
end of procedure
2.4.3
Select
Line
Type
T1
or
E1
Procedure 8: Selecting line type T1 or E1 using the CLI
Follow this procedure to select the appropriate line type using the CLI manager.
Action Steps
Log in
Press Enter.
At the
username
prompt, enter
admin
.
At the password prompt, enter
password
.
Get line type
Enter
get line type
.
RESULT:
The system returns the line type for all four
ports, as in the following example:
Line type [T1/E1]
Set line type
Enter
set line type [T1/E1]
where
T1
sets the line type to T1 for all 4 ports.
E1
sets the line type to E1 for all 4 ports.
RESULT:
The system acknowledges the new setting for
line type for all four ports, as in the following example:
Line type [T1/E1]
Reset system
Enter
reset
.
RESULT:
The system responds
Resetting
, then
immediately resets both Ethernet Interfaces and all 4
T1/E1 interfaces without asking for a confirmation.
CAUTION!
The previously configured line type
remains in effect until the system is
reset. Therefore, this step should
always be followed by a reset.
end of procedure
Issue
3
