3.3
Attaching and Removing the Accessory Connector Cover
The accessory connector is on the antenna side of the radio enables you to connect accessories to the
radio.
NOTE:
To prevent damage to the connector, shield it with the connector cover when not in use.
Attaching the Accessory Connector Cover
Procedure:
1
Insert the hook end of the cover into the slot above the connector.
2
Press the top of the cover downward to place it in the slot.
3
Rotate the thumbscrew clockwise.
Removing the Accessory Connector Cover
Procedure:
1
Rotate the thumbscrew counterclockwise until it disengages from the radio.
NOTE:
If the thumbscrew is too tight, use an allen wrench to loosen it.
2
Rotate and lift the connector cover to disengage it from the radio.
3.4
Attaching the Belt Clip
Procedure:
Align the grooves of the belt clip with the radio and insert it until you hear a click.
3.5
Charging the Radio
Prerequisites:
WARNING:
To avoid possible explosion:
• Do
not
replace the battery in any area labeled
Hazardous Atmosphere
.
• Do
not
discard batteries in a fire.
When and where to use:
Motorola Solutions-approved battery shipped with your radio is uncharged.
Prior to using a new battery, charge it for a minimum of 16 hours to ensure optimum capacity and
performance. For a list of Motorola Solutions-authorized batteries and chargers available for use with
your radio, see
NOTE:
When charging a battery attached to a radio, the radio must be turned off.
Procedure:
1
Turn off the radio while charging in a single or multi-unit charger.
MN009203A01-AA
Chapter 3 : Getting Started
29