6A
2
3
5
4
1
1
2
3
4
5
30~100mm
30~100mm
350mm
EN
03. INSTALLATION
ASSEMBLE THE SHAFT
Leave an excess of 350mm on the spring shaft beyond the bracket. Insert a protective
washer onto the shaft.
FITTING THE MOTOR
Place the motor on the shaft leaving about 3 to 10 cm on both sides of the motor (detail A).
MARK THE HOLES
Place the plate on the motor without tightening it completely.
Place the plate against the wall and mark the holes.
DRILL THE HOLES
Remove the motor plate and drill holes to secure the motor.
FIX THE MOTOR
Fasten the plate to the wall and then to the motor.
Place the protection ring on the shaft, touch the motor and tighten it.
AUTOMATION INSTALLATION
• The gearmotor must be installed in a protected area, without risk of damage.
• The fixing surface must be solid.
• Appropriate accessories must be used to fix the motor to the fixing surface.
• Install pipes suitable for the passage of electrical cables, in order to guarantee full protec-
tion against mechanical damage.
• The door frame must be strong enough, with efficient hinges.
• There must be no friction between fixed parts and moving parts.
DETAIL A
You can install the motor horizontally or vertically, the procedure is the same.
See detail A.
